Rear Sway Bar Reinforcement Brackets

2010 Forester XT
Upper and lower brackets fit great.

2014 Outback 3.6R
Upgrades:
ADF 2" front and 2 1/2" rear kit
ADF upper and lower sway bar brace
20mm sway bar oem
Nameless rear tower strut bar
etc....
If you're installing both braces, do the upper first, it makes your life easier for the lower brace. Upper took me about over 2 hour on both side (New England Rust got to them) and an hour and half for the lower. Upper took due to rust and Torqing it to 90 ft lb on your back, beside those 2 reason took me 5 mins to put them in and hand tighted everything to spec, the lower issue was the trailing arm bolt and that's all 5 mins install fighting by hand then torq at the end. all hand tools no Impact (tired of snapping bolts) FYI this is the perfect time to replace your end links, bushing and brackets while you have everything apart. as you can see in the picture the brackets and bushing is 1 winter old here.
With the setup I had before the brace, I was getting a probably 50% to 60% improvement from stock. With these upper and lower, it feels like May A$$ is slammed to the ground around corners, and I notice less nose lifting/weight transfer when flooring it. Dodging Boston break-checkers highly approved upgrade

Installed the brackets on a 2015 Crosstrek with a 2” lift in about 15 minutes. Probably helped that I had just installed the lift a week ago so the bolts weren’t all rusted up. Could use a longer bolt through the inboard attachment (would be good to have as part as the kit). A little concerned that the nuts will back off during use. That’s the reason I gave the review 4 stars instead of 5….. Overall, the upgrade looks good and was easy! Can’t wait to see how it affects the driving experience.

I am using these on a 2012 outback with a Whiteline BSR49XZ 22mm swaybar and KLC200 adjustable end links. The whiteline reinforcement brackets were not a good fit, while these upper mounts and reinforcement brackets were a perfect fit with easy install. Fantastic design and quality! I did change the lower swaybar bracket bolt to a JIS 10.8 flange M8x1.25mm x 30mm length vs the 25mm ones included, to make it a quicker install.

Had a small issue of getting 2 of the same part but it was taken care of immediately.